SYNOPSIS
#include <nng/nng.h>
int nng_recv(nng_socket s, void *data, size_t *sizep int flags);DESCRIPTION
The nng_recv() receives a message.
The flags is a bit mask that may contain any of the following values:
NNG_FLAG_NONBLOCK-
The function returns immediately, even if no message is available. Without this flag, the function will wait until a message is received by the socket s, or any configured timer expires.
NNG_FLAG_ALLOC-
If this flag is present, then a “zero-copy” mode is used. In this case the caller must set the value of data to the location of another pointer (of type
void *), and the sizep pointer must be set to a location to receive the size of the message body. The function will then allocate a message buffer (as if bynng_alloc()), fill it with the message body, and store it at the address referenced by data, and update the size referenced by sizep. The caller is responsible for disposing of the received buffer either by thenng_free()function or passing the message (also with theNNG_FLAG_ALLOCflag) in a call tonng_send().
If the special flag NNG_FLAG_ALLOC (see above) is not specified, then the
caller must set data to a buffer to receive the message body content,
and must store the size of that buffer at the location pointed to by sizep.
When the function returns, if it is successful, the size at sizep will be
updated with the actual message body length copied into data.
| The semantics of what receiving a message means vary from protocol to protocol, so examination of the protocol documentation is encouraged. (For example, with a req socket a message may only be received after a request has been sent, and a sub socket may only receive messages corresponding to topics to which it has subscribed.) Furthermore, some protocols may not support receiving data at all, such as pub. |
The NNG_FLAG_ALLOC flag can be used to reduce data copies, thereby
increasing performance, particularly if the buffer is reused to send
a response using the same flag.
|
RETURN VALUES
This function returns 0 on success, and non-zero otherwise.
ERRORS
NNG_EAGAIN
|
The socket s cannot accept data for sending. |
NNG_ECLOSED
|
The socket s is not open. |
NNG_EINVAL
|
An invalid set of flags was specified. |
NNG_EMSGSIZE
|
The received message did not fit in the size provided. |
NNG_ENOMEM
|
Insufficient memory is available. |
NNG_ENOTSUP
|
The protocol for socket s does not support receiving. |
NNG_ESTATE
|
The socket s cannot receive data in this state. |